Controllers and Sensors
This section covers the control units that manage dosing pumps together with measuring probes and sensors. The catalog includes the Kontrol 40, 42, 65, 100, 102 and 800 series along with probes and calibration solutions.
-
Calibration Fluids
Explore
-
CHECK 40
- Power Supply 100 – 240V 50/60 Hz
- Protection Class (IP) IP65
-
CHECK 42
- Power Supply 100 – 240V 50/60 Hz
- Protection Class (IP) IP65
-
CHECK 65
- Flow Rate 0 – 99,999 l/h ± 0.5 Hz
- Temperature 0 – 100°C ± 1°C
- pH 0 – 14 pH ± 0.01 pH
-
CONTROL 100
- Power Supply 100 – 240V 50/60 Hz
- Protection Class (IP) IP65
-
CONTROL 102
- Flow Rate 0 – 99,999 l/s, l/min, l/h, m³/h, GPM ± 0.5 Hz
- Temperature -50 – 150°C ± 0.1°C
- pH 0 – 14 pH ± 0.01 pH
-
CONTROL 800
- Flow Rate 0 – 99,999 l/h ± 0.5 Hz
- Temperature 0 – 100°C ± 0.2°C
- pH 0 – 14 pH ± 0.01 pH
-
CONTROL 800 TECH
- Power Supply 100 – 240V 50/60 Hz
- Protection Class (IP) IP65
-
Sensors and Probes
Explore
There are no products matching your search on this page. Clear the filter or change the category.
About Controllers and Sensors
The accuracy of a dosing system depends less on the pump than on the accuracy of measurement: the control unit compares the value read by the probe with the setpoint and drives the pump accordingly. Probe selection, calibration routine and measuring range can therefore matter more than the pump's flow rate.
Units in our catalog measure pH (0–14 pH ± 0.01), ORP (± 2,000 mV), electrical conductivity (0.054–200,000 µS), dissolved oxygen (0–20 ppm), free chlorine (0–200 ppm), amperometric chlorine (0–5 ppm), bromine (0–10 ppm), ozone, hydrogen peroxide and peracetic acid (0–99,000 ppm), turbidity (0–4,000 NTU), suspended solids (0–30 g), temperature (-50–150 °C ± 0.1 °C) and flow.
The units run on a 100–240 V 50/60 Hz supply and are IP65 rated. Calibration solutions allow regular calibration to prevent the probe reading from drifting over time — maintaining dosing accuracy depends on this.